How do you clean Argus C3?
Remove the six screws holding the front plate to the camera. Remove counter disk and rangefinder plate (3 screws), and carefully clean windows and mirrors, blowing dust from the mechanisms. With brush and solvent, clean all old lubricants on moving parts and shutter blades. Carefully wipe parts and allow to dry.
Do they still make Argus Cameras?
More recently, the Argus brand has been reestablished and is used on a variety of inexpensive digital cameras made by Argus Camera Company, LLC., located in Inverness, Illinois.
How do I calibrate my Argus C3?
Until you’re at the 3-foot mark then just replace the stuff allard gear screw just put it back on it turns clockwise. And there you go the rangefinder is calibrated and the lens is back on.
Does the Argus C3 have light meter?
Running Film
My father’s camera offers a purely analog shooting experience, with neither a battery or light meter to rein you in (although a later version, the Argus C3 Matchmatic, did boast an exposure meter on top).
Is an Argus camera worth anything?
Unfortunately, most Argus camera models are not worth a great deal. However, there are a number of less common to very rare models that command a modest to (rarely) very high price. Value will also vary depending on condition and included accessories.
When did the Argus C3 come out?
1939 to
The Argus C3 was a low-priced rangefinder camera mass-produced from 1939 to 1966 by Argus in Ann Arbor, Michigan, United States. The camera sold over 3 million units, making it one of the most popular cameras in history.
How do you open the Argus C3?
Open the camera by depressing the catch at the end of the camera. Pull out rewind knob on the bottom of the camera, and insert the 35mm cartridge. Then push the rewind knob in (it may be necessary to turn it slightly). Thread end of film completely through the slot on the takeup spindle.
What kind of film does an Argus C3 use?
35MM film
Argus C3, in working condition. The camera is also knows as “the Brick” equipped with a 50mm f/3.5 Cintar anastigmat triplet lens, Speeds from 10 to 300, with “I” and “B” switch, Coupled rangefinder. Interchangeable screw mount lenses (not the same as M42 screw mount) Uses any 35MM film.
What film does Argus C3 use?
What is the value of an Argus C3 camera?
Argus: Argus C3
| Average | Very good | |
|---|---|---|
| Body only | $10-20 | $10-20 |
| With lens | $10-20 | $20-30 |
| Estimate value accuracy: |
When was the Argus C3 made?
History. The C3 was introduced in October 1939 as an improved version of the C (1938) and C2 (1938–42). All three models shared the same “brick” design, attributed to Gustave Fassin, but the C3 was by far the most successful.
How do you date Argus C3 camera?
1958 – 1966: Stamped on the bottom of the camera body as a ten-digit number. For these cameras, the year of production is indicated by the fourth digit of the serial number; the quarter of that year (1-4) is indicated by the fifth digit of the serial number.
How do you open the back of an Argus camera?
Turn the lock (on camera bottom) to open and remove the back. Move the film wind lever with your thumb (on a C44R) or turn the wind knob (on a C44) until it will go no further. Then rotate the film takeup spool with your thumb until the flat side and roller are facing up.
What year is the Argus C3?
The Argus C3 was a low-priced rangefinder camera mass-produced from 1939 to 1966 by Argus in Ann Arbor, Michigan, United States. The camera sold over 3 million units, making it one of the most popular cameras in history.
What is the Argus C3 made of?
Bakelite plastic
The C3 was constructed primarily of Bakelite plastic and metal castings. The design featured an unusual but simple diaphragm shutter built into the camera body, so the camera could make use of interchangeable lenses without the need for a complex focal plane shutter.